GloPoxy Kit - Ecopoy

Get the brightest and longest glow in the dark with this GloPoxy set. Available in 2 colors, the product charges from any light source. Manufactured using a special color balance process, GloPoxy is stable. Durable and resistant to uv rays, it resists water, abrasion and chemicals that can be used indoors and outdoors.

Caracteristics:

• Coverage: 38 sq ft / L (3,5 m² / L) for 10 mils
• GloPoxy results in the brightest glow with extended glow in the dark duration
• Light absorption and release processes of GloPoxy can be repeated endlessly
• Any light source will charge GloPoxy
• Low Odor, NO VOC's NON Toxic
• 100% solids content for incressed build
• UV stable, durable, chemical, water and abrasion resistant for indoor & outdoor.
• Produces an exceptionally tenacious etching bond for high adhesion
• Excellent hardness and wear resistance
• Self-leveling finish

Other informations:

• Mix ratio: 4:1
• Pot life time: 20 minutes depending on ambient temperature
• Cure time: 48 hours for a 10 mil coat
• Set to touch time: 6 to 8 hours
• Minimum recoat time: 6 to 8 hours 
• Storage temperature: At room temperature
• recommended surfaces: Wood, plaster, metal, masonry and more

Surface Preparation:

Coat over clean, dry surfaces. Remove all grease, oil, wax, or other foreing matter. All surfaces must be sanded. Do not apply directly over paint.

Application Methods:

This product may be applied by using a 3/8" nap roller or foam brush.

Recommended Spread Rate:

10 mil.

Limitations:

Apply when air and surface temperatures are above 16°C (60°F). Surface temperature must be a least 10°C (50°F). For optimum application properties, bring material to 21-27°C (70-80°F) temperature range prior to mixing and application. Once surface is prepared correctly, blend GloPoxy and apply to surface. In a dry clean container blend 4 parts resin to 1 part hardener by weight. Mix thoroughly for 2.5 minutes at 450-600 rpm. Transfer batch from mix container to transport container. Apply mixed content from transport container to surface immediately.

Notes:

If 24 hours elapsed from time of application then additional preparation is required, Lightly sand entire surface with 80 grit sand paper until a light powdery residue appears and gloss finish has been removed to provide a profile for bonding. Remove all sanding dust and wipe down entire surface with denatured alcohol or isopropyl to remove contamination.